2
Now that your panel is mounted and powered up, you are ready to learn in your sensors.
First you will need to get into Installer mode on your panel.
1.
The first display will be Not Ready or Ready, press the Next key until the display reads
Installer Mode, when it does, press Show/OK. You will now be prompted to enter the Installer
Code, which is 9999 by default; press Show/OK when done.
2.
When you see New Instl Code, press Next and you will see Enrolling. Press Show/OK to
select.
3.
When you see Enrolling Type, press Next and you will see Enroll WL Device. Press Show/OK
to select, then press Show/OK repeatedly till you see Zone --. Press Next once to select the
zone 1.
4.
Press Show/OK to accept, and it will display Transmit Now. You will now need to transmit a
signal from the device you are enrolling.
5.
If it is a door sensor, open and close the sensor, or if a motion detector wave your hand in front
of it. At this point your panel should beep several times and you should see a black box next the
the word Zone 1.
6.
Press Next to select the next zone and repeat steps 4 and 5 for the enrollment of the next device.
7.
If enrolling a Keychain remote, follow the above steps up to step 3; and instead of selecting
Enroll WL Device, press next one more time to select Enroll Keyfob, when prompted to
transmit now simply hold down any one of the buttons on the keychain remote till the system
beeps.
8.
At any point in programming you can back up a step by pressing the HOME button; when you
are done enrolling your devices, you can press the HOME key repeatedly to exit out of
programming, pressing the Show/OK button when prompted.
Now, you can define your desired zones