MENUS AND FUNCTIONS
22
D-307503 PowerMaster 360 User's Guide
B.4 Programming User Codes
PowerMaster-360 system allows you to authorize up to 48 people to arm and disarm the system by providing
each with a unique 4 digit personal security code, and assigning them with different security levels and
functionalities. Moreover, you can obtain up to 32 multi-function portable keyfob transmitters that will allow you
and the other users to easily arm, disarm and control the system without accessing the panel, including from
outside the premises (see section B.7 Add / Delete Keyfob Transmitters). The Duress Code enables you to
disarm the system using a special code that sends a silent alarm to the monitoring station.
There are two types of users: Master User and User. The table below summarizes the different operations that
can be performed by different users:
User type
Function
Master User
Arm/disarm
Zone bypass
Authorize other user codes
Set user codes
Report to private
Enroll/delete proximity tag
Enroll/delete keyfob
Automatic arming
Enable squawk
Set date and time format
Read event log
Programming the duress code
Read the control panel serial
number
Read the current IP address of
the PowerLink
User
Arm/disarm
Zone bypass options
The user codes are assigned as follows:
User Code 1
is assigned to the Master User of the system (i.e. the owner). It is the only user code that allows
access to the User Settings menu. The default setting of the Master User code is 1111. This code cannot be
erased and must be replaced with a secret code as soon as possible.
User Codes 2-4
are assigned to family members, co-workers etc. They enable arming and disarming of the
system or of selected partitions as defined by the Master User. They can access the "User Settings" menu only
for "zone bypassing" provided this option is enabled in the Installer Mode menu.
User Codes 5-8 are
the same as user codes 2-4 but can be assigned to "Latchkey" (child monitor) users. For a
detailed explanation of the Latchkey application see Chapter 2 (Arming in the Latchkey Mode) and Appendix C.
Partition Option
(For information about Partition option - see Appendix B)
Your alarm system can divide zones into up to 3 parts (groups) via the Installer Mode menu. These parts are
designated as partitions P1, P2 & P3. Each partition can be armed and disarmed separately providing
protection to selected parts of the premises.
Each user out of the 48 system users can be authorized by the Master User to arm and disarm any combination
of partitions including all 3 partitions.
Here you can program (or edit) the 8 User Codes and thereby define which of these will be authorized to
arm and disarm.
1. The default setting 1111 of the Master User Code is the same for all PowerMaster-360 systems and is
known to many other people. Therefore, we highly recommend that you immediately replace it with a
unique secret code.
Never set any user code the same as any installer code.
2. Code "0000" is not valid! Do not use it.
3. The duress code (2580 by default), which is set in the Installer Mode menu, cannot be selected as a
normal user code. Any attempt to program it will be rejected by the system.
4. Carefully read the section titled "Additional Information" according to the indicated references
1
etc. –
see table at end of this section.
