D-303486 KF-235 PG2 User's Guide / Guía del usuario / Guia do utilizador
1
KF
KF
KF
KF----235 PG2
235 PG2
235 PG2
235 PG2
ENG
Wireless PowerG 2-Way Keyfob - User's Guide
ES
Mando 2 Vías PowerG Inalámbrico - Guía del usuario
PT
Dispositivo de Chaves Seguidas de 2 Vias PowerG Sem Fios - Guia do utilizador
ENG
ENG
ENG
ENG
1. INTRODUCTION
KF-235 PG2 is a PowerG keyfob, for use with the PowerMaster panels.
Commands are invoked by pressing any of the four command buttons. Status is indicated via the Status LEDs and buzzer after every command.
2. INSTALLATION
2.1 Enrollment
Refer to the PowerMaster panel's Installer Guide and follow the procedure under the
"
02:ZONES/DEVICES
02:ZONES/DEVICES
02:ZONES/DEVICES
02:ZONES/DEVICES
"
option of the Installer Menu.
Step 1
Step 2
Step 3
Step 4
Enter the Installer menu and select
“
02:ZONES/DEVICES
”
Select "
ADD NEW DEVICE
"
See Note 1
Enroll the keyfob by holding the
button and release it as soon
as the yellow LED lights, or, enter the
device ID (on the back of keyfob)
Select the desired Keyfob Number
for the new keyfob
Step 5
Step 6
Step 7
Notes:
1
. If the keyfob is already enrolled,
you can configure the keyfob
parameter and assign partitions
via the
“Modify Devices”
option
– see Step 2.
2.
PARTITIONS will appear only if
PARTITIONING was previously
enabled in the panel.
Enter PARTITIONS.
See Note 2
Assign partitions by pressing the
,
and
buttons
Select "Device Settings" and see
below to configure the (AUX) button.
means scroll
and select
2.2 Configuring the New Keyfob Template
Enter the
menu and follow the configuration instructions for the KF-235 PG2 keyfob as described in the following table.
Option
Configuration Instructions
Here you select the function of the "
∗
∗
∗
∗
" button on the keyfob device.
Options:
Arm instant
(default);
Not Used
;
Status
,
Stop Beeps
,
Skip exit delay
, and
PGM
*.
Not Used:
No function assigned to the AUX button.
Status:
Control panel displays and announces** the system status.
Stop Beeps:
The control panel and other devices in the system stop beeping (for example during exit or entry delays).
Skip exit delay:
Immediately stops the exit delay and causes the system to arm.
PGM:
Activates the PGM output.**
Arm instant:
While exit delay is in progress, this will cause the system to arm instant – (the entry delay is canceled).
* For UL Listed product, it is not permitted to enable either
Stop Beeps
or
PGM
.
** Applicable only to control panels that support the voice option.
3. USING THE KEYFOB
3.1 Keyfob Functionality
Step
Functions
User Actions
ARM/DISARM LED Indication
1
Arm AWAY
Blue LED above AWAY button lights
Arm HOME
Blue LED above HOME button lights
AUX A
DEVICE SETTINGS
F01:DEV SETTINGS
F02:P1
P2 P3
F02:PARTITIONS
MODIFY DEVICES
ID No. 301-XXXX
F02:Keyfob
ENTR ID:XXX-XXXX
ENROLL NOW or
ADD NEW DEVICES
02.ZONES/DEVICES
