D-306217 GB-502 PG2 Installation Instructions
4
Mounting the Device
For mounting the device with a bracket, refer to the BR-1, BR-2 or BR-3 Installation Instructions. Note that you can also mount the device without a BR
bracket.
1. Fasten the breakaway segment to the wall.
A. Mounting holes
B. Break-away base segment
C. Fastening screw
Figure 7. GB-502 PG2 Internal View
Attention!
The GB-502 PG2 has a back tamper switch under the PCB. As long as the PCB is seated firmly within the base, the switch is pressed
against a special break-away base segment that is loosely connected to the base. Be sure to fasten, using screw C, the break-away segment to
the wall. If the detector unit is forcibly removed from the wall, this segment will break away from the base, causing the tamper switch to open!
2. Put back the cover on the base and secure with screw.
Figure 8. Closing the Cover
Enrollment of the Device
Refer to the PowerMaster panel's Installer Guide and follow this procedure under the "02:ZONES/DEVICES" option of the Installer Menu.
1. Enter the Installer menu and select “02:ZONES/DEVICES”.
02.ZONES/DEVICES
ð
2. Select "ADD NEW DEVICE". Option.
ADD NEW DEVICES
ð
3. Enroll the device or Enter the device ID.
ENROLL NOW or
ENTR ID:XXX-XXXX
ð
4. Select the desired Zone Number.
Z04:Glass Break
ID No. 160-XXXX
ð
(with panels PowerG V.19.1 & lower)
ID No. 161-XXXX
ð
(with panels PowerG V.19.2 & higher)
5. Configure Location & Zone Type Parameters.
Z06.LOCATION
Z06.ZONE TYPE
ð
means scroll
ww
and select
OK
.
