VisionTrack FLEET FOCUS FF1000, Руководство пользователя

Страница: 5 / 21

7
INTRODUCTION
BACK
Record LED
BLUE LED
Warning LED
RED LED
Panic Record Button
G‐Sensor Calibration button
Power Cable
Black (Ground)
Red (Power +)
White (External panic )
Blue (External panic button ‐)
Green (Alarm out1), Low(0V) to High (5V) 2seconds
Yellow (Alarm out2), Low(0V) to High (5V) 2seconds
External Panic Button
(optional Item)
Cable length: 2m90cm
Button Case Size: 18 x39x10 mm
8
FUNCTIONS
Automatic Booting
Once the FF 1000 has been wired to your car power source the FF 1000 will be
boot up, this will take around 1 minute for the unit to be ready to record.
The default setting for record is the continuous recording at 30fps, 720P
resolution. This setting allows for separate event and panic recordings. On this
setting the SD card storage may be used up quicker and depending on the settings,
overwrite or stop recording when full. To avoid losing valuable data, back up data
to a separate storage or PC device after any incidents.
Continuous Record (When Record mode set as “Continuous”)
This is the default mode for recording. In this setting the unit will begin recording
after boot up and record the entire time the unit is powered.
The resolution and frame rates can be set as per your requirements. You can change
the configuration of the recording using the
FF
1000 Software. To do this, please see
the ‘Settings’ section on page 15.
NOTE: The unit will not start recording immediately after power on. It takes
around 1 minute for the built‐in power backup system to charge. Thereafter, the
internal flash memory will be ready to record.
Event Record (When Record mode set as “Event”)
The unit will record when triggered by either an impact or a push of the ‘PANIC’
button. In such events, 15 seconds of pre and post events will be stored separately on
the SD card.
NOTE:
When recording at 30fps, (1080P HD) resolution, separate event files (Shock and
Panic) will not be stored. If you wish to keep separate event files, change the
settings to a lower resolution or frame rate.
For example, 1080P @ 10fps or 720P @ 30fps
Parking mode: If G‐Sensor value is not changed during 5 minutes, the record
frame rate will be automatically change to 1FPS. When a vehicle starts to move
then the parking mode will switch off automatically and start the continuous
recording immediately
This “Parking mode” can be set when the record mode set as “Continuous”.
7 8
FUNCTIONS INTRODUCTION