HEATER
HEATER button
: Turns heater on and off.
NOTE:
The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE:
To prevent overheating, the heater
fan will blow cool air for 8-10 seconds
before the heater turns on, and after the
heater turns off.
1.
Press once
. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2.
Press again
. Indicator lights up.
1500W heater turns on and blows hot air.
3.
Press again.
Heaters turn off.
The fan blows cool air for 10 seconds to
allow heater to cool down, then turns off.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
Small remote control uses one
CR2025
battery
(
Included
)
Big remote control uses two
AAA
batteries (
Not Included
)
NOTE: Remote control battery used depends on the remote control type which selected above.
NEVER
dispose of batteries in
fire.
Failure to observe this precaution
may result in an
explosion
. Dispose of batteries at your local hazardous material processing center.
Care and Maintenance
Cleaning
ALWAYS
turn the heater
OFF
and
unplug the power cord from the outlet
before
cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in
electric shock, fire, or personal injury
.
NEVER immerse in water
or
spray with water.
Doing so could result in
electric shock,
fire, or personal injury.
12
