Pair the Device
When power on, press the “S1” button on the back of the exit button, then the blue light will flash, it means the
device is on pairing mode. Press the button on the remote control one time, then the buzzer sound once, it means it
has been paired successfully, Press “S1” button again on the back of the exit button to exit the pairing mode. You
can pair up to 30 remotes maximum.
Remark:
1. If no activity during 30 second it will quit pairing mode.
2. If during pairing mode button S1 is not pressed to exit the pairing mode in 30s then the system will return to
normal mode and will not save the pairing.
Delete the Device
Exit Button Wiring Diagram
Hold the “S1” button on the back of the exit button
for 5 seconds and the light will flash , then release
the “S1” button.
Green
White
Yellow
Black
Red
NO
NC
COM
GND
DC12/24V
J1
Select the Programming Mode
There are 2 programming modes:
Put the jumper on the N Port:
Momentary mode (Open door with any button on the remote and the door will close
itself after 4 seconds.)
Put the jumper on the L Port:
Latch mode (One button to open and the other button to close with the remote
control.)
Technology Within Your Reach
VIS-7102
ref.
Indoor ABS No Touch Infrared Request To Exit
Button With Time Delay + Built-in 433MHz
Wireless Re 2-Button 433MHz
Transmitter (Remote) Kit
Disclaimer:
VISIONIS reserve the right to go ahead with any modifications of models or features or price without forewarning. All the
information and specifications stated in this document are current at the time of publication. Attention: We are not responsible for the
improper installation of this kit. If you are not handy with electrical equipment you should contact a professional electrician. You will also
need to check with your local Fire authority to see if you need anything else to comply with local Fire Codes. We are not responsible for
any damage or fees that can occur.
www.visionistech.com
