Page
10
/
16
Installation using Wall Mount Bracket
①
Make a hole whose diameter is 30~40mm on
the mounting surface to pass the wire(s) and
cable(s) through the mounting surface. (In case of
the wiring and cabling through the mounting
surface only) Then prepare the wall mount
bracket. Pull the wire(s) and cable(s) for the
system as below. Attach the wall mount bracket to
the mounting surface. (Hex Lag #14
×
50)
②
Hook up “Drop Prevention Spring” on main
body to prevent camera from unexpected
drop and pull the wire(s) and cable(s) for the
system as below.
③
Line up the mold lines and assemble main body to
mount adaptor and turn it. And assemble the main
both with the camera mount adaptor with the
screws. (Torx screw M4X18). Please make sure the
screws are tightly assembled for waterproof.
④
Screw the dome cover to the main body
and remove the protection vinyl from
the dome cover.
Notice
l
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
Spring Wire Hook
END
START
