Vision VN310SFHD, Инструкция по эксплуатации

Страница: 19 / 21

19
Version 1.0.0
Release Date: July. 04.2013
7. Troubleshooting
If there are problems in operating, please refer to the checklist below. If the problem
persists, please contact the agent where this product is purchased.
Problems Troubleshooting
Nothing appears on the screen.

Please check that the power cord and line connection
between the camera and the monitor are fixed properly.

Please check that you have properly connected VIDEO
cable to the VIDEO output jack of the camera.
The image on the screen is dim.

Is lens stained with dirt? Clean your lens with soft, clean cloth.

Set the monitor to proper condition.

If the camera is exposed to too strong light, change
the camera position.
The image on the screen is dark.

Adjust the contrast feature of the monitor.

If you have an interim
device, set the 75Ω / Hi-z properly.
The camera is not working
properly, and the surface
of the camera is hot.

Please check that you have properly connected the camera
to an appropriate power source.
Color is not correct.

Please check the setting of AWB menu .
The screen flickers continually.

Please check that direction of camera turns toward the Sun.
RS-485
communication fails.

Please check the polarity between RS-485 Control Port
and RS-485 cable.
485 Control Board Connection Port RS-485 Control Port
(+)CONNECTION TERMINAL(TRX+) 485+
(-)CONNECTION TERMINAL(TRX-) 485-

Please check the RS-485 Communication establishment
initial value.
*RS-485 Communication establishment initial value
Item Camera ID BAUD RATE UART MODE RET PKT
Initial value 001 9600 8-NONE-1 ENABLE

We recommend that you make ground connect
between camera and controller in order to maintain
safety communication control.