2
Vision-64 User Guide
Issue 1.03
Copyright
©
2002-2005 Digflex Pty Ltd
COPYRIGHT NOTICE
Copyright
©
2002-2005 by Digiflex Pty Limited, Sydney, Australia
All rights reserved. No part of this publication may be reproduced,
transmitted or stored in a retrieval system in any form or by
any means, electronic, mechanical, photocopying, recording, or
otherwise, without the prior written permission of Digiflex Pty
Limited.
TRADEMARKS
Throughout this document trademark names may have been used.
Rather than put a trademark symbol in every occurrence of a
trademark name, we state that we are using the names only in an
editorial fashion and to the benefit of the trademark owner with no
intention of infringement of the trademark.
NOTICE OF LIABILITY
While every effort has been taken the accuracy of this document,
neither Digiflex Pty Limited nor any of its official representatives
shall have any liability to any person or entity with respect to any
liability, loss or damage caused or alleged to be caused directly or
indirectly by the information contained in this book. Should you
find any error on inconsistency, please notify us accordingly.
Digiflex Pty Limited reserves the right to make changes to features
and specifications at any time without prior notification in the
interest of ongoing product development and improvement.
TELEPERMIT NOTE
The grant of a Telepermit for a device in no way indicates Telecom
acceptance of responsibility for the correct operation of that device
under all operating conditions.
This equipment shall not be used in any manner that could constitute
a nuisance to other Telecom customers.
Immediately disconnect this equipment should it become physically
damaged, and arrange for its disposal or repair.
The transmit level from this device is set as a fixed level and because
of this there may be circumstances where the performance is less
than optimal. Before reporting such occurrences as faults, please
check the line with a standard telepermitted telephone.
Warnings
1) This product must be installed by a qualified and licensed
security installer.
2) This product may not perform as expected if installed
incorrectly.
3) Some features of this product require a working telephone
line to operate and telephone communication service
provider charges may be applicable.
4) Australian standard AS 2201 require regular service by
qualified and licensed security persons and regular user
testing. Please consult your security alarm company for
further details.
5) Incorrect programming of options can result in operation
contrary to what may be desired.
6) Leave the mains adapter plugged in at all times.
7) Leave the telephone line plugged in at all times under normal
conditions.
VISION-64
Security Controller
Document Part Number MACC110U
Document Issue 1.03
Date Released 10 March 2005
Firmware Revision 1.03 or higher
Hardware Revision D or higher
NOTICE TO OWNER
Thankyou for selecting the Vision Security Control Panel for your security needs. Your system includes many advanced features and
functions which will be programmed and configured by your security consultant during installation. Depending on the configuration,
and your access level, you may have the ability to program certain features within the system to suit changes in your security needs. For
example you may wish to change a User Name or PIN number when a staff member leaves.
This manual explains all aspects of system operation as well as detailling the various programming options available to you. We ask that
you take the time to read this manual carefully and that you have your installer explain the basic system operation and configuration to
you when the installation is complete.
