Clip-On Aerobar installation
1. Vision clip-on bar clamps are
Φ
31.8mm diameter. Ensure handlebar is compatible with clip-on aero bars and is
Φ
31.8mm diameter. FSA reccommends using carbon installation compound between clamp surfaces and handlebar,
especially on clip-on compatible carbon handlebars. DO NOT apply grease to any of the clamping surfaces.
Installing clip-on aerobars on a non-compatible handlebar can cause damage to the handlebar and may result in accident, injury or death.
2. Install Upper and Lower Clamps
③
, on
④
the handlebar
①
. Move the clamp plates to the desired width. Alternately tighten Clamp Bolts to 60 kgf.cm / 6 Nm / 53 in.lbs.
②
To ensure clamping security and safety, install clip-on bars only on the round center section of handlebar. Do not install clip-on bar on any tapered or shaped section of handlebar.
Installing clip-on bar in any location other than the round center section may cause slippage or damage to handlebar or aerobar resulting in loss of control, accident, injury or death.
3. Install Aero Extensions in to Upper Clamp
⑥
④
and Armrest Mount . Set to desired length. Alternately tighten
⑤
Aero Extension Bolts to
⑦
60 kgf.cm / 6 Nm / 53 in.lbs.
4. Choose the desired armrest position and attach the Armrest Plate
⑧
to Armrest mount
⑤
. Install Armrest Plate Fixing Bolts and Washers and tighten t
⑩
⑨
o 60 kgf.cm / 6 Nm / 53 in.lbs.
Always use a calibrated torque wrench to tighten armrest fixing bolts.
Always install the armrest bolts with washers. Installing armrest bolts without washers can cause armrests to crack and fail unexpectedly while riding resulting in loss of control of bicycle.
5. Remove the adhesive velcro strips
⑪
from armrest pads
⑫
and attach to the top surface of left and right armrest plates.
6. Press Aero Extension Front and Rear Plugs
⑬
,
⑭
in to aero extension.
Use only supplied Vision bolts for installation. Using bolts other than original supplied bolts may cause damage to extension bar threads resulting in armrest plate position deflection while riding, resulting in loss of
control of bicycle and can cause serious accident or injury. Apply threadlocker to the fixing bolts threads.
Team Clip on aerobars must not be trimmed or cut from the front or rear. Cutting aerobars will void the warranty.
Team Clip-on aerobars are not compatible with bar-end shifters. Using bar-end shifters with Team Clip-on aerobars will void the warranty.
