Vision X Xmitter Prime Extreme, Инструкции по установке и Руководство пользователя

Страница: 4 / 8

VISION X
MANUFACTURER RECOMMENDATION
For those unfamiliar with electrical wiring on vehicles, Vision X
recommends that all LED Lighting products are professionally
installed
.
WIRING INSTALLATION INSTRUCTION
1. Find a suitable place to mount Relay Part (R1) leaving
enough room for Power & Ground wires Part (W1 & W2)
to reach the battery & the Deutsch connector Part (C1) to
reach the Light. Mount Relay.
2. Run Power wire (W1) & Ground wire (W2) to the battery.
Connect the Power wire (W1) to the Positive (+) battery
terminal and connect the Ground wire (W2) to the Negative
(-) battery terminal.
3. Run the Deutsch connector wire (C1) to the light and plug
in.
4. Disconnect the Switch Part (S1) at the white Plug Part (P1)
and run the wire through the vehicles fi re wall to desired
mounting location inside the Cab [using a factory rubber or
plastic grommet is suggested].
5. Drill the hole to the required size for the Switch (S1) and
mount to desired position.
6. Reconnect the Switch (S1) to the Harness.
7. Test Light.
DIMMING FUNCTION
Your light is capable of dimming through the Prime Drive wire
on the light’s plug. To achieve this requires our authorized
accessories, the XIL-PDIMMER, or XIL-PDIMMERBUTTON.
Do Not connect the Prime Drive wire without authorized
accessories as this will damage the electronics.