MOUNTING INSTALLATION
1)
Determine where the light/lights will be placed
2)
Hold mounting bracket with light to desired mounting surface. Using a marker
or pick tool, mark the bolt hole on the desired mounting surface
3)
Set the light aside. Find the center point of the hole you have marked out and
drill out a large enough hole to fit the 5mm bolt [Part M1]
4)
Remove the Mounting Bracket from Light by unscrewing the (2) 5mm Allen
Head Bolts [Part M4], one on each side
5)
Set Bracket down on Desired Mounting Surface, Lining up the Hole in the
center of Mounting Bracket with the Hole you just Drilled, Slide 5mm Bolt
[Part M1] through both
6)
On the other side of Mounting Surface slide 5mm Washer [Part M2] and 5mm
Nylock Nut [Part M3] onto 5mm Bolt. [Part M1] Tighten Nut [Part M3] & Bolt
[Part M1] to Desired Tightness
7)
Hold Light in Mounting Bracket while screwing in the (2) 5mm Allen Head Bolts
[Part M4], one on each side. Use 5mm Allen Key [Part M5] to tighten both 5mm
Allen Head Bolts [Part M4] to Desired Tightness
WARNING: Bolts, Nuts, & Washers are Stainless Steel.
Do Not Use Pneumatic or Electric Tools to Tighten & Loosen
or the Hardware Will Permanently Lock Together
LIGHT ANGLE ADJUSTMENT
1)
Use the 5mm Allen Key [Part M5] to loosen each of the Allen Head Bolts
[Part M4] on either side of the light.
2)
Adjust the light until you have your desired angle.
3)
Then, tighten the Allen Head bolts [Part M4] to hold the desired position.
Adjustment Key
Part (M4) 5mm Locking Bolt
(M4)
(Mounting Bracket)
MOUNTING KEY
Part (M1) Bolt (5mm)
Mounting Bracket
Part (M2) Washer
Part (M3) Nut (5mm)
(M2)
(M3)
(M1)
(Mounting Bracket)
VISION X OPTIMUS SINGLE KIT
