Solstice Solo Prime
Installation Instructions
Washington Warehouse
901 Algona Blvd N.
Unit F
Algona, WA 98001
Ph: 888-489-9820
Fx: 253-218-2905
Arizona Warehouse
6501 E. Greenway
Suite 103-542
Scottsdale, AZ 85254
Ph: 800-994-4460
Fx: 480-922-5655
www.visionxusa.com
Page 2 of 2
3. The Solo series pigtails come pre stripped with solder terminations. If you are using crimps, remove
solder terminations buy cutting each wire individually and re-strip each wire individually before crimping. If
soldering, to avoid a “dry” solder make sure solder is well embedded into the copper strands.
4. After making your connections, heat shrink each individual connection to avoid shorting of wires and
exposure of the copper to the elements.
5. With all of the connections made and insulated with heat shrink you now can plug in and test.
Adjust light
–
Adjust the light to the desired horizontal height, then use the supplied Allen wrench to tighten both side Allen bolts
on each end. A good reference point is at 20 ft; the top of the beam should be 3” down from center of light (with
the light bar at dead center). Tighten light and enjoy.
Warning
–
•
Make sure all wiring is away from hot surfaces and moving parts.
•
After installing lights be sure to position lamps so they do not blind other drivers. Position your vehicle
approximately 20 feet from a wall. The top of the beam projected on the wall should be 3 inches lower
than the lights center.
•
Do not place lights near anything flammable after being used.
•
Some vehicles create high voltage upon starting or shut down, do not have lights on when staring or
turning off the vehicle.
•
Lighting laws and regulations vary by state. Check your local laws before using.
•
Let lights cool down before handling after use.
•
Do not look directly into lights; doing so can cause eye damage.
Lifetime Limited Warranty
–
1. Proof of purchase is required to validate warranty and is valid from the original date of purchase. All
products must be bought through a Vision X Authorized Dealer or one of their dealers/resellers.
2. Improper installation, accident, abuse, neglect and normal wear are not covered under warranty.
3. Lights operated in environments over 150
o
Fahrenheit are not covered under warranty.
4. Warranted items will be repaired to working condition and returned without cosmetic alterations.
5. All customer warranties should be handled through the dealer/reseller the product was purchased from.
6. If product is not under warranty, clients will have to cover shipping charges both ways.
7. Additionally, non-warranted items can be repaired at the customer’s expense of parts and labor, at the
discretion of Vision X, who will provide an estimated repair cost before proceeding with the repair.
A Complete Single or Two light Relay Harness is Available from Vision X
For installation\technical information contact your Vision X Reseller.
For more mounting applications including helmet and handlebar mounts; Visit www.VISIONXUSA.com
Product Tested By:
