Solstice Solo Prime
Installation Instructions
WARNING! – Only use included wiring to wire the Solstice Solo Prime. Even though
the plug is the same as other Vision X wiring, the Solo series has unique circuitry
that can easily be damaged with wiring other than the included pigtail.
Package Contents;
1. Solstice Solo Prime Series Pod
2. Wiring Pigtail with Deutsche Connector
3. Universal Stud Mount
4. Allen
Wrench
Required Tools;
1. ¼” Drill Bit
2. 10mm Socket and Ratchet
3. 10mm Open End Wrench
4. (2) 16 Gauge Barrel Crimps or Soldering
Iron, Solder and Heat Shrink
5. Crimper
6. Wire
Stripper
7. Included Allen Wrench
Mounting Instructions;
1. Drill ¼” Hole in desired mounting location.
a. Note – The center of your hole will be the exact center of the light. Make sure to measure the
location of your hole before drilling.
b. Note – If you are linking multiple pods together using the included Omni-Link connector, carefully
read linking instructions on the bottom of the next page before selecting placement of mounts.
2. Insert stud mount through the ¼” hole and tighten the nylock nut with a 10mm socket or wrench to a
maximum torque of 20 ft/lb.
a. Note – DO NOT use air impact tool as they will damage the stainless threads.
3. Remove adjustment set screws if installed on adjustment bracket. Tighten the adjustment nylock snug
against the bracket and aim the light to desired position. After the light is aimed, tighten the adjustment
bolt and nylock to a maximum torque of 20 ft/lb. If desired insert and hand tighten adjustment set screws
for use in high vibration scenarios.
Wiring Instructions;
The Solstice Solo pod draws .75 amps at 12 volts. A relay harness is always recommended in vehicle
applications running more that (5) Solo Pods. Vision X does offer these for sale. A maximum of 25 Solo pods per
30 amp 12 V DC relay is recommended. If the vehicle does not have a battery one will be needed. Battery packs
are also available for purchase. For stationary applications, 9-50 V DC is required to operate the pods.
Note:
The yellow\green wire on the light is the prime drive control wire, used for controlling dimming
functions. Do not connect this wire to anything other than a Vision X Prime Drive Dimmer Controller.
Attaching this wire to battery power or ground may cause damage to the light and void your warranty.
1. Before making any connections, unplug all of the Solo pods to avoid damaging the internal electronics.
2. Each Deutsche connector pigtail consists of a red and black wire. Red is your positive (+) input and Black
is your negative (-) wire input.
Washington Warehouse
901 Algona Blvd N.
Unit F
Algona, WA 98001
Ph: 888-489-9820
Fx: 253-218-2905
Arizona Warehouse
6501 E. Greenway
Suite 103-542
Scottsdale, AZ 85254
Ph: 800-994-4460
Fx: 480-922-5655
www.visionxusa.com
Page 1 of 2
