Vision Fitness V-SERIES, Руководство пользователя, Страница: 9 / 28

V-SERIES
Page 9
The cycle tune-up must be performed at initial installation of the VISION V-Series for optimal performance and
longevity. Please read and follow all instructions below. If the VISION V-Series is not installed and tuned as
described, components may wear excessively and the VISION V-Series may become damaged. If you have
questions about the installation, please contact Vision Fitness.
Note: Some maintenance procedures require WD-40 (refi llable spray bottle recommended) or Brunox spray
lubricant, and White Lithium grease.
1. Make sure that the VISION V-Series is level. If the VISION V-Series rocks on the
fl oor, turn the leveling feet underneath the front and/or rear stabilizer until the rocking motion is
eliminated.
2.
Verify Emergency brake function to assure that emergency brake functions correctly.
3. Brake pad calibration: Turn resistance knob counterclockwise as far as possible (minimum bra-
king effect), verify that there is a slight separation of the brake pad from fl ywheel. Brake pad
should barely touch the fl ywheel when resistance knob is turned counter-clockwise as far as it
can go.
4. Apply WD40 or Brunox spray lubricant to the brake pad. Make sure brake pad is thoroughly
soaked from end to end with lubricant spray. Then, wipe the excess off from the fl ywheel.
* Best Practice: Use a refi llable spray bottle fi lled with non-aerosol WD-40 purchased by the
gallon (3.7 L) at the local hardware store.
5. Apply Lithium grease to the threads on the lower end of the brake rod. First, turn the resistance
knob clockwise until it stops. Apply a small amount of white lithium grease to the threads on the
brake rod above the two lock nuts. Then, turn the resistance knob counter-clockwise until it stops.
6. Apply Lithium grease on the metal threads of all the adjustment knobs.
7. Check four (4) Allen nuts on RS pulley for tightness. If loose, apply LocTite Threadlocker Blue-
242 and retighten.
8. Check R and L crank arm Allen bolts for tightness. If loose, apply LocTite Threadlocker Blue-242
and retighten.
9. Verify belt tension. Check if belt drive is fi rmly tightened and does not slip while riding under
a resisted load. In case that the belt slips, proceed using the adjustment technique as described
on page (18). Please note that a belt drive gear never shows slack. During adjustment do not
apply too much tension.
10. Wipe down bike frame with cloth moistened with WD-40
11. Some parts of the VISION V-Series may become loose during shipment. Check crank arms,
check all exposed screws, bolts, and nuts, and make sure that they are properly tightened.
Customer Service
1. Provide basic maintenance instructions to client and direct them to the detailed maintenance
instructions provided in this manual.
2. Sign-off sheet provided to client to confi rm explanation of maintenance procedures/manual and
to verify the condition of bikes.
INITIAL INSTALL CHECKS