TO30/9.1-85-F10-B-RF
Commissioning
6.2.1 Mounting at the clamping area
The assembly of the lens takes place at the clamping area (1). The appropriate
mounting adapters are available as accessories.
1. Loosen the socket head cap screws of the objective holder.
2. Place the objective holder in the desired position in the clamping area.
3. Tighten the socket head cap screws of the objective holder by hand.
6.2.2 Mounting of filters
Lens filters are connected to the lens via the filter connection (2).
1. Insert the filter into the filter thread (2) of the lens.
2. Screw the filter to the lens hand-tight.
6.2.3 Mounting at the camera
The lens is connected to a suitable camera via the C-mount connector (3).
1. Attach the lens to the C-mount connector on the camera.
2. Screw the lens to the camera hand-tight.
© Vision & Control GmbH 2019
999.995.930.10-en-2.2
27
