ViscoTec Preeflow eco-CONTROL EC200-B, Инструкция по эксплуатации и обслуживанию

Страница: 18 / 36

18 / 35 Version 1.9 Copyright ©
eco-CONTROL EC200-B
Operation and maintenance instructions
5.10 Settings
5.10.1 Dosing amount
General on determining the dosing amount.
Note: If a value that differs from 100% is set in the
Calibration manual
menu
(section
5.9.2
), this affects the results of the dosing.
There are two options to choose from:
A) Determination via calculation
It is easiest to determine the smallest dosing quantities by weight. We recommend that
you first set the material density.
Dose the required amount with the
start / stop program
and weigh it out. Now input in the
quantity program
the quantity in g .
B) Teach in, empirical determination
Use the Teach in function if you wish to determine the required amount by means of doing
(for example, filling a void). The Dosing system saves the required amount.
• Confirm the flow rate and set the desired value with the
NAVI wheel
• Press the
OK
button,
system selection menu
, display 2
appears.
D
is
pl
ay
4
0
Setting the dosing amount as a value
1. Press the
Quantity program
shortcut key, display 3
appears.
2. Ensure that the required quantity unit* has been selected
in the
Quantity
display area.
3. Set and confirm the dosing amount.
D
is
pl
ay
3
* If the saved density value corresponds to the value 1.000 g/cm³ (default value), the
input dialog for the material density appears when you select g . See 5.10.5, Material
density, page21.
Setting the dosing quantity with the Teach in function
Note : The Dosing system cannot be operated by either the foot switch or an external
control signal can be used during the Teach In function.
Accept with OK
Esc
Calibration manuel
OK
degree of dosing qty
Adjustment range 90% ..110%
100.0 % 100.0 % 100.0
Quantity program Esc
Suckback Flow rate Volume
0% 100%
ml/min
00.100 03.000 00.000
ml ml