Virtus L 60, Руководство пользователя

Страница: 58 / 78

PART A: Basic machine
Shredder
L 60; L60+
©
VIRTUS EQUIPMENT 2018 All rights reserved
Page 58
8.9.8 Mounting the stator knives
WARNING
Danger of cutting caused by sharp knives, even when the ro-
tor is at a standstill.
Serious injury, particularly to hands and fingers, can result.
Wear protective gloves.
Proceed as follows:
Illustration:
(1) Stator knife
(2) Knife holder
(3) Knife holder fixing
screws
(4) Knife adjusting screw
for pushing
(5) Knife adjusting screw for
pulling
(6) Cover plates
(7) Cover plate fixing
screws
(8) Cover plate holder fixing
screws
(9) Cover plate holder

Remove old knives (see dismounting the stator knives )

Insert sharp knife or turn old knife.

Put in the knife adjusting bolts for pushing and adjust them rough-
ly

Put in the knife adjusting bolts for pulling and tighten lightly first
Adjust the gap between rotor and stator knife to 0.8-1.0 mm
by using the adjusting bolts.

Tighten constant both knife adjusting bolts for pulling by using a
torque wrench.

Tighten constant both knife adjusting bolts for pushing by using a
torque wrench.
The required torque for all knife mounting bolts M12 is 120Nm
The required torque for all knife adjusting bolts M16 is 295Nm
(also see the table under Replacing and checking the cutting knife
mountings).
3
6
1
2
9
7 (M12)-
120Nm
4 (M16)-295Nm
5 (M16)-295Nm
8