VIRTUFIT HTR 1.0, Руководство пользователя

Страница: 13 / 32

ENGLISH
EN
13
Exercise bike squeaks: Check that all bolts and nuts are tight. If
necessary.
Ticking noise when pedalling:
This may be caused by one of the
pedals. Remove the pedal(s) and mount it (them) correctly on the unit.
Tighten the pedal(s) firmly. If this does not solve the problem, contact
the supplier.
NOTE!
The "R" (right) pedal must be mounted clockwise and the "L"
(left) pedal must be mounted counter-clockwise.
The hand sensors are not working properly: Wash your hands, dry
them well and test the hand sensors again. If this does not solve the
problem, check the handlebar cables for damage and ensure that they
are properly connected to the connector. If this still does not correct
the problem, replace the handlebar.
Console does not work: If there is no signal when pedalling, check that
the cable is correctly connected.
CONSOLE (FIG. A)
• SET Sets the values for: "TIME" DISTANCE" and "CALORIES".
• CLEAR With this button the value can be reset to 0.
• RESET Press and hold the reset button for 3 seconds to clear
the setting.
• MODE Press the MODE button to select the desired function.
• ODOMETER Automatically counts the total distance of alle
exercise sessions 0.0 ~ 9999 KM.
Functions
• TIME Press "MODE" until "TIME" is displayed. The time measured
since the beginning of the exercise is displayed.
• SPEED Press "MODE" until "SPEED" is displayed. The current
speed during the exercise is displayed.
• DISTANCE Press "MODE" until "DISTANCE" is displayed. The
unless otherwise specified by the supplier or manufacturer.
Cleaning
General cleaning of the unit will extend its life. Keep the appliance
clean by dusting it regularly. Regular maintenance will prolong the life
of your appliance and prevent injuries! For more information, please
visit https://www.virtufit.nl/service/faq/
CAUTION!
Wear clean shoes to reduce the risk of soiling the
machine. At least once a year, remove the cover to remove dust.
Battery
AAA BATTERIES
The display uses AAA batteries, which are replaceable on the back of
the display. The batteries must be inserted correctly.
If the screen is unreadable or only parts of the image work, proceed
as follows:
• Remove the batteries and wait 15 seconds.
• Replace the batteries correctly.
Tips on using the battery
• Remove the batteries from the screen when they are empty or
when the camera will not be used for a long period of time.
• Do not recharge, disassemble or dispose of batteries in fire.
• Pay close attention to the + and - when inserting the batteries.
When replacing batteries, it is recommended to replace all
batteries, do not mix old and new batteries.
• It is recommended to use alkaline batteries, they have a longer
life than normal batteries.
• Batteries should be replaced when the display loses brightness
or stops showing.
Battery replacement
• If the display is not accurate, it is recommended to replace the
batteries.
• Use 2 x AAA batteries for power.
TROUBLESHOOTING
The display does not show any values: Check that the sensor and
console cables are properly attached and undamaged. If this does not
solve the problem, carefully bend the sensor.