COMPOSS | User's manual
4
6. TROUBLESHOOTING
PROBLEM
SOLUTION
1. VF-ControlPanel does
not show "Connected" in
COMPOSS Status
although COMPOSS is
plugged in the computer.
Make sure COMPOSS device is
recognized by the computer, go to
"Control panel"->"Devices and printer".
Virtual Fly - COMPOSS device should
be shown there. If it is not shown, try
connecting the COMPOSS to a different
USB port or through a powered USB HUB.
2. VF-ControlPanel does
not show "Connected" in
FSX/P3D Status.
Make sure you have FSUIPC module
installed on FSX/PREPAR3D and FSX/
PREPAR3D is running when you check
this point.
3. When COMPOSS
device is plugged in
a USB port, after find
the initial position, the
position shown is not
"North".
COMPOSS is not properly calibrated.
Execute VF-ControlPanel, go to "open
calibration panel" and follow the
instructions for COMPOSS calibration.
4. The indicated compass
position shown in
the FSX/PREPAR3D
or X-Plane 11 aircraft
differs from the position
indicated on COMPOSS
device.
Make sure you are comparing Compass
instrument in the FSX/PREPAR3D or
X-Plane 11 aircraft and not the Gyro/HSI
instrument. If the position differs, execute
VF-ControlPanel, go to "open calibration
panel" and follow the instructions for
COMPOSS calibration.
5. VF-CONTROL PANEL
- Refresh: Performs a device and software scan.
- Backlight: Control for Composs backlight activation and deactivation.
- Open calibration panel: A guided step by step calibration process for
Composs calibration.
Note that Composs device is calibrated in factory and this process is not
required unless Composs is not properly calibrated.
- Test: Let the user test the Composs device and calibration.
