Configuring the Analog Modem
Setting up and Configuring the Analog Modem
© Virtual Access Ltd.
Page 8 of 14
2.5.1
Setting up the analog modem for dial-out management
Follow the steps described in
section 2.3
to set up the modem for use as
primary WAN interface, select call for permissions and configure the outgoing
destination number to be the phone number to which the managed SMG is
connected.
The IP routing table must be configured to route traffic destined to Activator
over PPP-1.
2.5.2
Setting up the analog modem for dial-in management
Follow the steps described in
section 2.3
to set up the modem for use as
primary WAN interface. Use PPP-8 for PPP interface. Select answer for call
permissions. The IP routing table must be configured to route traffic destined to
Activator over PPP-8.
2.6
SMG Boot-Mode Maintenance over V.92
If SMG fails to boot up or is placed into boot-loader mode, it is possible to use a
number of low level maintenance functions by making a modem call to SMG
accepted on modem interface. The SMG will automatically connect an incoming
modem call and present the user with the management menu. An example
session is shown below.
Connected to Virtual Access Service Managed Gateway.
Press ENTER for the command prompt
#>
?
Select one of the following help menus:
help general
help debug
help flash
