Iss 1 - Feb 2018
Page 4 of 9
Status LED arrangement
On the EcoLite charge point, the operating state is communicated to the user via two LED
arrangements: An illuminated ‘Charge Point’ text and an illuminated halo on the front.
LED
Operating State and description
Text
Halo
OFF
OFF
Charge point is not active, Switched off
Possible Cause of issue:
No mains power present
Electrical protection switched off
Fault with charge point
WHITE
BLUE
A - Charging station is waiting ready to be connected to an electric
vehicle
BLUE
BLUE
B - An electric vehicle is connected but not charging
GREEN
GREEN
C - An electric vehicle is connected and charging
RED
BLUE
D - An electric vehicle is connected but ventilation is required. This
mode is not supported by Viridian EV charge points so will not
charge.
RED
(Pulsing)
OFF
Fault detected, charging is not allowed. See troubleshooting or seek
technical support.
LED Brightness
The LED brightness is configurable at the point of installation (or after during maintenance). There are 4
settings: MAX, MEDIUM, LOW & HALO OFF. Ask your installer about this if you wish it to be
changed.
Connecting / disconnecting your electric vehicle
To begin a charging session
For charging stations equipped with a built in cable:
Open the socket inlet flap on the vehicle and insert the vehicle coupler into the electric vehicle.
You may need to apply a small amount of force to ensure that the plug is housed firmly within
the socket.
For charging stations equipped with a socket:
Lift the hinged flap of the socket on the charging station and fully insert one end of the vehicle
interconnecting cable in to the socket.
Take the other end of the vehicle interconnecting cable and insert it into the vehicle as described
above.