Viqua WS series, Руководство пользователя

Страница: 27 / 29

Quick Reference Guide
27
Section 7 Quick Reference Guide
General Operation
When the system is operating, one of the following four displays
will be shown:
• “TIME OF DAY/GPM”, “FLOW RATE”, “CAPACITY
REMAINING” or “DAYS TO A REGEN”.
• Pressing NEXT will toggle between the three choices.
Manual Regeneration
Note: For softeners, if brine tank does not contain salt, fill with
salt and wait at least two hours before regeneration. If you need
to initiate a manual regeneration, either immediately, or the
same night at the pre programmed time, for regeneration
(typically 2:00 AM), complete the following steps.
1 Press and hold REGEN until valve motor starts (typically 3
seconds).
2 Press and release REGEN (notice that flashing appears).
To Set Time of Day
In the event of a prolonged power outage, time of day flashes,
indicating that this needs to be reset. All other information will
be stored in memory no matter how long the power outage.
1 Accessed by pressing SET CLOCK .
2 Adjust hours with
U
and
V
buttons, AM/PM toggles at 12.
3 Press NEXT
4 Adjust minutes with
U
and
V
buttons
5 Press NEXT to complete and return to normal operation
Bypass
To shut off water to the system, position arrow handles as
shown in the bypass operation diagram below. If your valve
doesn’t look like the diagram below, contact your service
technician for instructions on how to shut off water.
Error
If the display toggles between “ERROR”
and an error code (i.e. a number),
call a service technician and report the
error code.
Adjust Hardness, Days Between Regeneration, Time of Regeneration and Alarm Buzzer
For initial set-up or to make adjustments, please complete the following steps :
Note: Hardness display shows “-nA-” if used as a filter. If other displays do not appear, refer to manual.
1 Accessed by pressing NEXT and
U
button simultaneously.
2 Adjust hardness using
U
and
V
buttons.
3 Press NEXT.
4 Adjust days between regenerations using
U
and
V
buttons.
5 Press NEXT.
6 Adjust time of regeneration hour with
U
and
V
buttons, “ AM / PM ” toggles at 12:00.
7 Press NEXT .
8 Adjust time of regeneration minutes with
V
and
V
buttons.
9 Press NEXT to complete and return to normal operation.
“REGEN TODAY” AND “TIME OF
DAY” WILL FLASH ALTERNATELY IF A
REGENERATION IS EXPECTED TONIGHT.
NORMAL OPERATION BYPASS OPERATION