40
© 2006 Directed Electronics—all rights reserved
2-8 ACTIVATION PULSE COUNT:
This feature allows the number of pulses to activate the remote start feature to
be changed from 1, 2, or 3 pulses. The pulse count programmed to start the vehicle will also be the same required
to shut down the remote start.
2-9 2nd IGNITION/ACCESSORY OUTPUT:
This will allow the PINK/WHITE to be used as a 2nd ignition or an acces-
sory.
2-10 ACCESSORY STATE DURING WAIT-TO-START:
This will allow the programming of the accessory wire during
the wait-to-start period of a diesel motor. When ON the accessory comes on when the wait-to-start output is
activated and stays on, dropping out during crank and returning once the car has started. When OFF the acces-
sory will activate as a normal accessory.
2-11 2nd STATUS OUTPUT:
This status will activate 10 seconds after the car has started. It is intended to operate
the defogger circuit. The output can be programmed to a latched or a pulsed output. When programmed to the
latched output the status will only stay active for 10 minutes.
2-12 ANTI-GRIND ON/OFF:
With the anti-grind On (default) the ground-when-armed output will be active during
remote start operation. If accessories such as a voice module or window module are added to the unit, it may be
necessary to program this feature off.
2-13 DIESEL TIMER—WAIT-TO-START
/15, 30, 45
SECONDS:
Default is the “Wait-to-Start” input control
wire, or programmable to ignore the input control wire by a delay of 15, 30, or 45 seconds. This feature
can be also programmed with the Bitwriter® and with a delay from 1 to 90 seconds.
2-14 RUN TIME (TIMER MODE)—12,
3, 6, 9
MINUTES:
Selects the time in minutes that the system will
operate the engine until the system "times out". This is the maximum operation period and the system
may be shut down using a shutdown at any time. Using the Bitwriter®, the run time can be programmed for any
duration from 1-16 minutes.
