Viper 75L, Руководство пользователя, Страница: 7 / 73

DRY & WET CARPET CLEANER ENGLISH
7
Introduction:
This manual is to be used for an understanding of Viper and a mastery of the operation and use of CAR275.
This manual should be read thoroughly before use.
This device is a commercial carpet cleaner.
Description of the construction of the device
For parts diagrams of the construction of CAR275, refer to “F1”Diagram on Page 3 and “F2” Diagram on
Page 4.
1. Headpiece handle hook 2. Power cord 3. Headpiece water pump inlet fast female connector 4. Water tank
fastener 5. Drain water tank hind fastener hook 6. Tank handle 7. Stainless steel drain water tank 8. On/off
switch panel 9. Headpiece water pump outlet fast female connector 10. Headpiece assembly 11. Stainless
steel foam protection mesh 12. Dust filter 13. Suction hose base button 14. Suction hose base 15. Draining
hose 16. clean water tank lid 17. Spare tank 18. 10-inch hind wheel 19. Water tank fastener 20. Clean
water tank hose fast male connector component 21. 25-liter clear water tank base 22. 3.5”directional wheel
23. Water drainage lid 24. Male connector component for the base of the suction hose 25. Connector for the
corrugated hose at the base of the suction hose 26. Corrugated hose 27. Connector for the corrugated hose of
the metal elbow end 28. Fast male connector of the metal elbow end 29. Threaded fast female connector of the
on/off switch panel 30. Control valve 31. Metal elbow end component 32. PU water hose 33. PU water
hose retaining clips 34. 110° nozzle 35. 10” transparent triangular rake component 36. Unscrewing sliding
button
Instructions
1. Fill the clean water tank with an appropriate quantity of clean water or soluble low foaming solution with
cleaning agents (Attention: No dirt and sand grains should be present). The soluble solution to be used to fill
the clean water tank must be kept at 5 cm below the water inlet of the clean water tank, in order to avoid
spilling when the machine is in operation. Turn the lid of the clean water tank tight.
2. Fix the headpiece onto the 75-liter drain water tank, and fasten well (Attention: for ease of use, the operation
control panel of the headpiece should face the direction of the suction set of the drain water tank).
3. Referring to the F2 diagram, connect well the metal elbow component, fix the triangular assembly, and adjust
to the appropriate direction of operation. Fix well the PU water hose retaining clips, and fix the on/off control
to the handle end of the metal elbow hose. Fix well the hexagon nuts. Insert the fast male connector of the
metal elbow hose end to the threaded fast female connector of the on/off switch panel.
4. Insert the flexible hose of the suction hose end to the suction hose end, and insert the water hose male
connector component to the fast female connector of the outlet of the headpiece water pump.
5. Insert the male connector component of the outlet hose of the clean water tank into the fast female connector
of the water inlet of the headpiece water pump.
(The way to insert and pull out the fast male and female connectors: Push forward the threaded sliding button,
insert the male connector, then release the sliding button, and it is locked automatically. When disconnection
is required, push the threaded sliding button of the female connector and pull out the male connector.)