VIPA 612-1BC00, Руководство пользователя

Страница: 31 / 62

Manual VIPA HMI Chapter 2 Deployment Touch Panel
HB160E - TP - RE_612-1BC00 - Rev. 08/37 2-11
Due to the fact that many components of the Control Panel are concurring
with the s ystem control of Windows
®
, most of the description is here
dispensed. The description of the control panel components relevant for
operating the Touch Panel is to be found in the following:
Set display
Via Start > Settings > Control Panel > Display the dialog windows for the
display properties opens. Here you may change the settings for the monitor
options.
For example you may adjust the brightness and contrast via the register
Settings .
Calibrate touch screen
If your touch screen does not always react on a double click or recognizes
the position of an entry not precisely, you may call the dialog
Stylus via
Start > Settings > Control Panel .
In the register Double-Tap you may use the grid pattern to preset a double
click velocity and test this on the symbol below. OK takes over the set
value. The calibration of the touch screens happens via the register
Calibration by following the instructions.
Set Ethernet parameters
The dialog field for pre-setting an Ethernet address is to be found at Start
> Settings > Network and Dial-up Connections.
The default setting is address assignment via DHCP.
System properties (System)
Here you receive information about the version of the current Windows
®
operating system, the memory load and sharing (alterations here are not
taken over into the registry) and about the copyright.
The register Device Name allows you to change the device name that is
e.g. shown during Ethernet communication.
Note!
All alterations made here are cleared after PowerOFF-PowerON. To store
them permanently into the registry file you have to store them explicitly. For
this, call “Save Registry” at
Start > Programs > KuK Tools . Use [OK] to
store the data in the registry file.
System setting
(Control Panel)