VIPA 606-1BC00, Руководство пользователя

Страница: 14 / 62

Chapter 1 Hardware description Manual VIPA HMI
1-6 HB160E - TP - RE_606-1BC00 - Rev. 08/13
Components
The following memory systems are available for every Touch Panel:
•
64MByte work memory
•
32MByte Flash-Disk (6MByte for user data)
•
USB storage media using "Host"-USB-A interface
•
Slot for CF (Type II)
•
Slot for MMC/SD
Every Touch Panel has a work memory with a size of 64MByte. The work
memory is not buffered and is deleted after shut down. Please regard that
also registry entries are stored in the work memory that are set back to
default settings after the next re-boot. You may save them permanently by
means of the
KuK Tools (within consignment).
As internal permanent storage medium every Touch Panel has a flash disc
with a size of 32MByte (6MByte user data). After the start of Windows
®
CE
this memory is listed as Flashdisk at My Device .
The connection of USB sticks and USB drives by use of the "Host"-USB-A
interface is supported by the Touch Panel. After connection the storage
media is listed as
Hard Disk at My Device .
Slot for CF
Here you may plug a C ompact F lash

type II. The card may be plugged
and removed during runtime and is immediately listed as Storage Card at
My Device .
Every CompactFlash

storage module has a pulling edge. Hold the
CompactFlash in the way that the pulling edge points to the left side. Push
the storage module without much power into the slot until the impact. To
remove the card touch it at the pulling edge and pull.
At this slot you may plug storage modules of the type SD or MMC. The
card may be plugged and removed during runtime and is immediately listed
as
SDMMC Card at My Device .
Please take care to plug the according card as shown at the backside of
the Touch Panel.
Security flap for
memory cards At the left side of the Touch Panel are the card slots for memory cards.
The cards are visibly covered by a security flap and are thus secured from
slipping out.
Please take care to pull the security flap back before plugging or pulling a
memory card like shown in the illustration and put it back again afterwards.
When plugging, the security flap additionally snaps into position above the
plugged memory card.
Memory
management
Work memory
Flash disc
USB storage media
Slot for SD/MMC