VIP Officebox Call&Fax, Руководство пользователя, Страница: 10 / 15

10
If during a call you want to take another call...
If during a call you receive another call, a sound signal will inform you about a new incoming call.
If the Hold option is activated, you can:
- Put the first call on hold and take the second call by pressing the keys in the following sequence:
By pressing these keys you can by turns switch from one active call to another.
or
- Replace the handset to end the first call.
In this case you do not reject the call on hold which is signalled to you by ringing as any other usual incoming call.
or
- Do not do anything, continue with you first call and the person attempting to call you will hang up, because you are not
answering his/her call.
Caller Line Identity Presentation (CLIP)
In case of incoming calls Officebox Call&Fax can display telephone number of the caller if your telephone supports
number display function.
To activate or deactivate CLIP function enter:
CLIP function activated, caller identity is displayed.
CLIP function deactivated, caller identity is not displayed.
Fax
By using standard analogue fax machine connected to the
Fax/telephone
port of Officebox Call&Fax device you can
send G3 fax messages. Fax machine is to be installed and used in line with its use instructions.
Note:
This device is equipped with very advanced fax technologies providing the best results of fax transmission
by GSM networks. Still, due to the nature of GSM fax transmission, the proper fax communication cannot
be granted always and on all locations.
“Wireless telephone line” used by Officebox Call&Fax has the following features which you should be familiar with:
Configure the connected fax machine so that the incoming call is answered after the first, second or third ringing tone,
and not later. Otherwise there may be problems with the receipt of fax messages.
In case an error occurs during fax sending, it may happen that your fax machine reports successful fax transmission.
In case of an error in fax transmission the Officebox
Call&Fax device will send your fax machine a message about an error so that you can correct the problem. Only in
case there is no message about an error you can be certain that the transmission has been completed successfully. You
can also activate the operating mode in which after each fax sending you will receive a transmission report (transmission
successful, transmission failed).