16/24-Port PoE Switch
©f---------------�
5
Port Management
5.1 Port Config
Port config can be used to configure each basic parameter which is related to switch port.
The port basic parameter will directly affect the working mode of the port, please make
config according to the practical requirements.
....
0,,
0,,
....
0,,
0,,
�
0,,
-
0,,
0,,
....
"'
"'
....
"'
"'
Figure 5-1
Refer to Figure 5-1 for the port config interface of the switch, in this interface you can check
description, link state, speed duplex status, flow control status of each port, you can also
add port description info, configure enable and disable state, speed, duplex mode and
flow control function of each port.
• Port: It displays the switch port number;
• Port description: it adds description information for port;
• Enable: It is to configure port on/off.
Refer to table 5-1 for port status config.
Status
Note
On
Config link is in the status of enable.
Off
Config link is in the status of disable.
Table 5-1
• Link: It displays the port link status.
Refer to table 5-2 for port status config.
Status
Note
Up
It means the link is in the status of enable.
Down
It means the link is in the status of disable.
Table 5-2
• Speed-current: It displays the current speed status of the port.
Refer to table 5-3 for the port speed duplex display.
Port
Current speed
Speed duplex mode
Ethernet port
Auto(default)
Auto-negotiation mode
10M FULL
10M Full duplex
10M HALF
10M Half duplex
100M FULL
100M Full duplex
100M HALF
1 DOM Half duplex
1000M FULL
1000M Full duplex
Fiber port
1000M-X
1000M Full duplex
Table 5-3
• Speed -config: It is to configure the port speed duplex mode.
Note
It will directly affect the port communication if you change port speed duplex mode; so
please modify it carefully.
Refer to table 5-4 for port speed duplex config.
Port
Current speed
Speed duplex mode
Ethernet port
Auto ( default )
Port speed duplex mode self-adaptation
10M FULL
Port speed duplex mode 1 OM full duplex
10M HALF
Port speed duplex mode 1 OM half duplex
100M HALF
Port speed duplex mode 1 DOM half duplex
100M FULL
Port speed duplex mode 1 DOM full duplex
1000M FULL
Port speed duplex mode 1 ODOM full duplex
Fiber port
1000-X
Fiber port is set as 1000M full duplex mode
Table 5-4
• Flow Control: It is to set switch flow control function.(The default setup is on).
On port flow control interface,
on
is to enable port flow control function and pause frames
can be sent or received normally,
off
is to disable port flow control function.
Note
For Ethernet port, please enable port flow control function to synchronize the inbound
speed and outbound speed in case there are packet losses resulting from the different
speeds.
5.2 Port Mirroring
Port mirroring (called port monitor) is the process of copying the packet passing through
a port or several ports (called a source port) to another port (called the destination port)
connected with a monitoring device for packet analysis. It is to monitor the network and
resolve the network malfunction. See Figure 5-2.
