Using screw M6*10 to fix the base legs to the base stem.
Using Hex Wrench 4mm fully
tighten the screw to make sure
the pole doesn’t wobble.
Using screw M10 to fix the pole to the base stem.
Assembling the arm with the pole,adjust to
the right position and fix it with the screw.
Assembling the post cap.
Pulling the holder to grip your advice.
Open cable clip two sides.
If you feel the pitching angle too tight or too loose when
adjusting the mount,please adjust the Screw.
Using M5*16 screw to fix the connector
with the back hole of holder.
As shown in the pic, assebling the connector
and fix it with the screw.
3
3
3
3
Max:44.5” (1130mm)
Min:8.5” (215mm)
As shown, the pole with
groove should face out.