F
B
C
E
≥ 18 in.
Wall
Loosen
Tighten
Wrench
D
A
E
WHITEBOARD
ASSEMBLY
Part 1
Frame Assembly
Step 1
Use a wrench to tighten the castors
A
into the
bottom of frame's sides
E
.
Step 2
Secure the top bridge
D
and bottom bridge
F
between the sides of the frame
E
. Use a
screwdriver to tighten up the screws
G
.
Part 2
Adding the Board
Step 1
Check to make sure the screws
G
are securely
installed then place the board
C
into the frame.
Make sure to use the notches in the sides of the
frame
E
and the rotation button on top of the
bridge
D
.
Step 2
Check to ensure the board
C
sits about halfway
into the rotation button on top of the bridge
D
.
Step 3
Install the end caps
B
into the top of the sides of
the frame
E
.
Part 3
Usage Instructions
Step 1
Keep the whiteboard at least 18 in. from the wall at all times.
Step 2
If needed, the board can be flipped to the other side without
turning the frame. To do this, press the rotation button down,
push the top or bottom of the board to rotate it. Let go of the
button to secure the board in place.
Step 3
To tighten the castors
A,
use the screwdriver and turn
clockwise. To loosen the castors
A,
use the screwdriver and
turn counterclockwise.
Use a screwdriver and
the screws
G
(x8)
to
fasten the frame
together. Make sure to
tighten the screws.
Note the notches
where the board
C
(x1)
will rest.
Rotation Button
Screwdriver
During assembly, using at least two
people is recommended due to the
size of the frame.
When tightening up the
castors A (x4), take care not
to scratch off the protective
layer on the bottom of the
frame E (x2).
