background image

©Vio Products Company, Inc. 

 

July 2007 rev1 

Operator Instructions--Wireless Pool Thermometer Model 11000 

 
 

STEP ONE – 

Insert batteries into 

POOL THERMOMETER

.      

 

1.

 

 Remove five screws from pool thermometer. 

2.

 

Gently separate top and bottom halves 

CAUTION:  GENTLY PULL STRAIGHT APART. DO NOT TWIST. 

3.

 

Using your finger, snap open the battery compartment door in the bottom half. 

4.

 

Insert two new 

AA

 

ALKALINE BATTERIES ONLY

, positive end first. 

CAUTION:  MUST USE ALKALINE BATTERIES ONLY  
                      FOR PROPER FLOTATION. 

5.

 

Snap battery compartment door closed. 

6.

 

 Align top-half, bottom-half and gasket. Insert and fully tighten 5 screws.   

NOTE:  INADEQUATE SCREW TIGHTNESS WILL CAUSE 
              LEAKAGE AND PERMANENT FAILURE. 

 

Keep the pool thermometer near the base station for now and go to Step Two.                                                  
  

 

STEP TWO – 

Insert batteries into 

BASE STATION

 

1.

 

If you will set the base station upright on a flat surface, snap the bracket onto the 
bottom of base station.  If wall mount is preferred, do not use the bracket. 

2.

 

Insert 2 AA ALKALINE batteries. 

3.

 

The base station will automatically search for the pool thermometer for 3 minutes. 

NOTE: YOU MUST WAIT 3 MINUTES TO CONTINUE. 

 

4.

 

The base station now displays the pool thermometer temperature on the top 
display and the indoor air temperature on the bottom display. 

5.

 

Float the pool thermometer in your pool.  (You may use the enclosed tether cord 
to restrict the flotation area.) 

6.

 

Place the base station on a nearby wall or window ledge inside your home. A line-
of-sight position between the base station and the pool thermometer is best. 

 

THE TEMPERATURE WILL BE UPDATED EVERY 3 MINUTES. 
               

  

PUSHBUTTONS 

CHANNEL AND MAN/SCAN PUSHBUTTON:   
Momentarily depress the button multiple times to select Channels 1, 2, or 3.   
Note: This device will display the pool temperature on 

Channel 1 Only

 
MAX/MIN AND RESET PUSHBUTTON: 
Push the button once to display the maximum recorded temperature. 
Push the button a second time to display the minimum recorded temperature. 
Push button a third time to return to the current temperature. 
While the display shows “MAX” or “MIN”, push and hold button for 3 seconds to 
RESET the recorded temperatures. 
The display will return to current temperatures after 5 seconds of not pushing the 
button. 
 
 

 

Отзывы: