Vinvautz VZ143VSUG, Инструкция по эксплуатации

Страница: 6 / 30

6
INSTALLATION OF YOUR WINE CELLAR
Before Using Your Wine Cellar
• Remove the exterior and interior packing.
• Before connecting the Wine cellar to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Check that the voltage marked on the product corresponds with your supply voltage.
• Clean the interior surface with lukewarm water using a soft cloth.
• When replace the illuminating lamp, please contact local service provider for replacement.
• When disposing your appliance, please choose an authorized disposal site.
Installation of Your Wine Cellar
• Place your Wine cellar on a floor that is strong enough to support it when it is fully loaded. To
level your Wine cellar, adjust the front leveling leg at the bottom of the Wine cellar.
• Locate the Wine cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
• Avoid locating the unit in moist areas.
• Plug the Wine cellar into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
• Important : If the lowest temperature is set during periods of high humidity and ambient
temperature, condensation may appear on outside surfaces and the door of wine cellar, this is a
normal phenomenon.
ATTENTION:
This wine cellar has been designed for freestanding and built under installation. In every case, there must
be adequate ventilation and access for service.
Freestanding installation will allow you to install the wine cellar in almost any indoor place you desired.
You must follow the stated instructions for electrical requirements, recommended install area and
leveling of the wine cellar.