23
Bottom clamp
15
The design of the bottom clamp changed at tripod Serial No. 03515. Identify version as follows
15.2 Using a suitable instrument, such as a flat-bladed screwdriver, carefully remove the knob cap
15.3 Remove the retaining screw
and washer
and pull off the clamp knob
.
.
15.4.1
Earlier clamps have a smooth shaft and are fitted with locking and adjusting
grubscrews. Loctite is used on these screws.
15.4.2
Later clamps have a groove machined in the shaft and are fitted with a single, longer,
adjusting grubscrew, retained by a locking thread insert.
Fig 4.3 ‘Pozi-Loc’ tripod leg - top clamp adjustment
(20.1)
(20.2)
(20)
Содержание pro-touch Pro-10 System
Страница 1: ...Contents Vinten Camera Control Solutions Next Page Previous View pro touch ...
Страница 38: ...38 Contents Previous Page First Page Next Page Previous View Fig 6 1 Pro 10 System 1 2 3 ...
Страница 47: ...47 Contents Previous Page First Page Next Page Previous View Fig 6 5 Pozi Loc Two Stage Tripod 3819 3 1 2 3 4 ...