10
Installation
12
12
15
15
13
Install the column on the skid as follows:
1.
Ensure that the rubber straps on each foot support (15) are to the
outside of the ball joint.
2.
Hold the column upright. Raise the struts (9 and 12) to about 30°
from the horizontal. The strut joints are adjusted to retain the struts
in this position.
3.
Lift the column. Align the fixed strut (with logo) with the fixed
leg of the skid and carefully lower the column base into the skid
centre,(see marking on skid for correct orientaion), at the same
time engaging the struts with the ball joints on each foot support.
4.
Secure the struts to the supports with the rubber straps (15).
5.
Tighten the skid clamp (13), using moderate hand pressure only.
The clamp lever has a spring loaded ratchet-type action and is
operated as follows:
6.
Turn the clamp lever clockwise as far as possible.
7.
Pull the lever outward against the spring pressure, return it
to vertical and release.
8.
Turn lever clockwise again.
9.
Repeat until the skid clamp is sufficiently tightened.
Column
Install the column on the skid as follows:
12
12
15
15
13
Содержание Osprey Plus
Страница 34: ...32 Notes ...
Страница 35: ......
Страница 36: ...Publication No V4170 4980 0 www videndum com ...