14
Installation
Pressurizing from an external pressure source
!
WARNING!
This pedestal must be pressurized only with clean, dry air or nitrogen. A
pressure reducing valve must be fitted to the pressure line between the gas cylinder
and the outlet connection of the hose. The reducing valve must be screwed into the
gas cylinder outlet. The maximum pressure on the outlet side of the reducing valve
must not exceed 11 bar (160 psi).
Do not
pressurize the pedestal beyond the maximum safe working pressure
indicated by the leading edge of the red sector on the gauge. The pedestal is fitted
with a pressure relief valve as a safeguard against over-pressurization.
Do not
attempt to adjust the pressure relief valve
.
To pressurize the pedestal from an external pressure source, proceed as follows:
1.
Fully depress the moving column (1) and engage the safety catch (2).
2.
Attach the intended payload, see
Fitting and balancing the payload
3.
Remove the Schrader valve cap (4) and connect the charging line (3) from the pressure source.
4.
Turn on the pressure supply and slowly increase the pedestal pressure to the required pressure. Do not
exceed the maximum working pressure, indicated by the leading edge of the red sector on the gauge
(5).
5.
Disconnect the charging line, but do not refit the Schrader valve cap at this stage.
1
2
4
3
5
1
2
4
3
5
Содержание OSPREY lite
