9
INSTALLATION INSTRUCTIONS AND DRAWINGS
1. Wine Cabinet’s dimension :
Height 820mm – 860mm (40mm adjustable feet)
Width 595mm
Depth 571mm
2. This wine cabinet is not designed to be fully integrated behind a joinery door.
3. Please note that a minimum cut out of 615mm is required to facilitate installation,
removal and servicing.
4. This wine cabinet requires 10mm clearance on both sides and top, 30mm clearance at
the rear. Where possible a ventilation grid should be installed in the 30mm clearance at the
rear (either in the sides, top or back of the joinery). Minimum grid size is 200mm x 40mm.
5. This wine cabinet is front venting. The wine cabinet draws air from the rear and expels
through the metal grid under the door at the front. If a kick board is to be placed in front of
the ventilation grid another grill must be fitted into the kick board with a minimum air
flow allowance of 150cm2.
6. This wine cabinet has a power switch located on the control panel so power point
location is not critical.
7. This wine cabinet requires a standard 240 volt/10 amp power point. ( Or other according
to each country specifications)
8. The power cord is 1.9m in length and is fixed on the right side at the back when looking
from front of cabinet.
9. As with most appliances of today, this cabinet has sensitive electronic components
which are susceptible to damage through lightning and electricity supply faults. It is
therefore advised to use a power surge protector to avoid problems of this nature.