background image

Instructions (VR-SR)

Step 1:

 

Verify wall surface

Verify wood thickness is at least 1/2” thick. 

Step 2:

 

Mark mounting hole locations

Mark the center-point of the first rail and, using a level to ensure 

the marks are on the same horizontal plane, mark the center-

point of the second rail 2 inches (51mm) away (figure a). 

Step 3:

 

Drill the anchor holes

Drill a 5/32 inch (4mm) pilot hole at the marked hole locations 

(figure b). If you do not hit a stud or solid wood, you will need 

to use Vino Series Stemware Rack with Collars (VRC-SR).

Step 4:

 

Install the Wood Studs

If supplied, use the hex key to drive the Machine/Lag Studs into 

the holes until the coarse threads of the lag screw are no longer 

visible. 

Otherwise, thread 2 nuts onto the fine threaded end of one 

Machine/Lag Studs and using two 10mm wrenches, tighten 

the nuts against one another (figure c). With the nuts tightened 

against each other, use one wrench on the outer nut and screw 

the lag end into the pilot hole in the wall. 

Thread the bolt into the wall until the coarse threads of the lag 

screw end are no longer visible, leaving just the finer threads 

exposed (figure d).  Again using 2 wrenches, loosen the nuts 

and remove them from the fine threaded end of the stud. 

3 3/4"

3 3/8"

2 1/2"

3"

3"

2 1/2"

2”

3.25”

figure a

figure b

figure c

figure d

Отзывы: