Instructions: Vino Pins Flex (VP-FLEX)
Figure A
Figure B
(OPTIONAL)
2. ADD VINO PINS EXTENSION PIECES
Thread one (1) Stud into each Vino Pin Extension for the
Bottle Neck (Figure A). Repeat the process for the Vino
Pin Bottle Base side. Vino Pins are designed to extend up
to three (3) total bottles deep for 750ml bottles and up to
two (2) bottles deep with spacer for magnum bottles.
3. ASSEMBLE THE PINS TO THE STRIP
Insert one (1) Vino Series Screw through the back of one
(1) Vino Pins Flex Neck mounting Strip and thread one
(1) Vino Pin Neck piece until tight against the surface of
the mounting strip (Figure B). Repeat until all Vino Pins
Neck pieces are attached to the Neck Mounting Strip,
and all Vino Pins Base pieces are attached to the Base
Mounting Strip.
4. CHOOSE BOTTLE DIRECTION
Before marking the mounting hole locations, decide
which direction you want the bottle necks to face to deter-
mine which order to mount the Base and Neck Mounting
Strips (Figure C).
5. LAY OUT WALL
The Vino Pins Flex can be mounted vertically or at angles
ranging from 45 degrees to 135 degrees.
Vertical Columns
Starting at least 2 3/4” (70mm) from adjacent wall or
other obstructions and 1” (25.5mm) from the ceiling,
mark the centerline of the first Mounting Strip (Figure D).
From there, measure the distance, noted in chart below
by bottle type, to centerline of the second Mounting Strip.
Hold one Mounting Strip (careful to note the top and
Neck side) in place against the wall, centered on the first
mark at your preferred distance from floor.
Ensure the Strip is plum using a level and mark hole
locations with a pencil (Figure E). Mounting Strips can be
installed on angles up to 45 degrees. Set strip aside.
Figure C
Figure D
Figure E
Centerline Measurements
• Vino Pins Standard (750ml): 7.5” (190.5mm)
• Vino Pins Magnum (1.5L): 8.5” (216mm)