Vintage VPMAXX, Руководство пользователя

Страница: 6 / 12

6
Burners
To light:
Remove Power Maxx burner cover.
Turn on gas supply to the Power Maxx burner.
Turn burner knob to “High” then push and hold the ignition button for 5
seconds. You should hear a rhythmic “clicking” sound. If you do not, turn
all knobs to “Off”, check ignition battery and ensure the burner base and
burner cap are properly positioned.
If burner does not light after 5 seconds, turn knobs to off and wait 5 minutes
before retrying. This will prevent any flare-ups over cooking surface, which
can result in injury.
Match lighting:
If ignition fails to light burners after several attempts or if the igniter battery
dies and you do not have a ready replacement, burners may be carefully
match-lit.
If match-lighting after a failed ignition attempt, wait 5 minutes before
attempting to light with a match.
Make sure knobs are in “Off” position. Light a long-stemmed match and
place over the burner. Keeping your face away from cooking surface, push
and turn control knob to “High”. If burner does not light in 5 seconds turn
knob to “Off” and wait 5 minutes before trying again.
Always wait 5 minutes before re-lighting a hot burner!
Note:
Improper lighting procedures can cause the flow control to activate, resulting
in reduced heat output. If this is suspected, shut off all burner controls and
cylinder valve. Wait 30 seconds, then very slowly re-open cylinder valve.
Wait an additional 5 seconds before turning burner control knob and
attempting to light.