Figure D
4.
Assemble the Vino Pins and Install -
If using the
optional Vino Pins Collars, slide one collar over each of
the studs protruding from the wall (Figure F). If using
Vino Pins extensions*, thread a stud into one end of the
base extension Pin and screw the starter base Pin onto
the remaining exposed end and firmly hand tighten (Figure
G). Connect any additional extensions in a similar fashion
and repeat this process for the neck pins. Thread the
assembled Vino Pins or the Vino Pins starter onto the studs
extending from the wall, ensuring that the base side is
secured to the lower stud and the neck pin attaches to the
higher stud and firmly hand tighten (Figure H).
3.
Install the Lag Studs
- Thread 2 nuts onto the fine
threaded end of one Machine/Lag Studs and using two
10mm wrenches, tighten the nuts against one another
(Figure D). With the nuts tightend against each other, use
one wrench on the outer nut and thread the lag end into
the pilot hole in the wall. Screw the bolt into the wall
until the coarse threads of the lag screw end are no longer
visible, leaving just the finer threads exposed (Figure E).
Again using 2 wrenches, loosen the nuts and remove them
to repeat the process for the second Machine/Lag Stud.
Figure G
Figure E
Figure H
Vino Pins with
Optional Collar
Vino Pins
without Collar
Vino Pins
Starter
Vino Pins
with one
Extension
Vino Pins with
2 Extensions
*Optional
Extensions
*Optional
Collars
Figure F
For product warranty information, please visit:
VintageView.com/support/warranty
We’re here to help, call us at 866-650-1500 with any questions.
US Patents: 6,991,117 and 7,850,017 China Patent: ZL 2006 2 0173305.3
*IMPORTANT NOTICE:
The Vino Pins are designed to accommodate a maximum of 3 bottles deep - 1 starter plus 2 extensions. Any
application outside of these parameters is not warranted by VintageView and may result in product and/or installation failure, property
damage and/or bodily injury.
Maintenance and Care -
The Vino
Pins should be regularly checked for
tightness. Should any Vino Pin be
found to be loose, tighten by hand until
secure. If the face of the wall surface
shows signs of breakage, discontinue
use immediately until such time as
the wall may be adequately repaired.
Vino Pins may be cleaned with a damp
cloth and mild detergent - abrasive
cleaners, pads or steel wool should
NOT be used as they may scratch the
surface.
