Make it Wide:
Add extension units
The Case & Crate Bins and Lockers are designed to modularly extend left or right, sharing the inside
Support Wall.
1. Stand the Bin/Locker Short or Tall upright.
2. Starting from the top, install all shelves in the same manner as Step 2
3. Attach the Side wall on the outside in the same manner as Sept 3a
4. Repeat for as many Extension units necessary.
Reference Figure C
Accessorize
Make it a Locker
Installation instructions are included in all Locker Door (CC-LOCKER) packages. If you don’t have the
Locker Doors already, find them at
vintageview.com/caseandcrate
.
Add an X-Bin
Installation instructions are included in all X-Bin (CC-XRACK) packages. If you don’t have an X-Bin al-
ready, find them at caseandcrate.com.
Enhance your Bin
Make it Tall:
Add a top unit
Build the top unit following Steps 1-3, removing the End
Caps from the base. Confirm that the base Bin unit has
the supplied Levelers attached to the bottom and the
End Caps removed from the top.
With the base Bin unit standing upright, insert supplied
Couplers to the top of the unit. Slide the top Bin onto its
respective set of Couplers.
For installations including Extension Kits, install the first top
Bin with the shelf nuts not secured (Step 3b), then connect
the extension shelves, followed by the Extension Kit Side
Wall. Repeat as many times as necessary.