4
www.vintageair.com
901230 REV D 06/24/19, PG 4 OF 9
Label Installation
1.
2.
3.
4.
Determine the orientation you want to use, horizontal or vertical, and install the label onto the 3-lever panel
assembly.
Install the (3) knobs onto the 3-lever panel assembly using the set screws as shown in Figure 1, Page 5.
NOTE: If mounting in vertical configuration, replace black oxide set screw with (3) stainless
steel set screws, Part #183989. If mounting in horizontal configuration use set screws included
with knobs.
After selecting the orientation for the panel, mask the area 2” (tall) x 4 ¼” (wide) for horizontal, 4 ¼” (tall)
x 2” (wide) for vertical.
Place and level the template onto the dash to cut out the opening.
WARNING! THIS OPENING MUST BE A PRECISE FIT. CUT OPENING UNDER SIZE, THEN FILE
TO FIT. IF THE OPENING IS OVERSIZED, THE PANEL MAY SHIFT DURING USE.
1
15/16”
1
11/16”
CENTER
TO
CENTER
WARNING! THIS OPENING MUST BE A PRECISE FIT. CUT OPENING UNDERSIZE, THEN FILE
TO FIT. IF THE OPENING IS OVERSIZED, THE PANEL MAY SHIFT DURING USE.
LEVEL THIS LINE FOR
VERTICAL
4
1/16
”
Ø
1/4”
3
13/16
”
CENTER TO CENTER
LEVEL THIS LINE FOR HORIZONTAL
3-LEVER
CONTROL PANEL
TEMPLATE
NOTE: Due to printing variances, measure the line below before using this template. If
template is scaled properly, the line should measure 6 inches.