- 6 -
Fig. 2.1 CUTOUT AND HOLE DIMENSIONS
•
The cooling unit produces cooling supplied into the cabinet, meanwhile it also
generates heat that must be exhausted outside the cabinet. So the cold-air
supply with return-air intake and hot-air exhaust with ambient-air side must be
separated and sealed. Foam tape gasket may be used to seal them. The
cooling unit must intake adequate fresh ambient-air to work properly. The
ambient-air intake and hot-air exhaust must not be short-circulated. A piece of
wood may be used to separate them.
•
Cut a rectangular inside opening at the rear of the cabinet with the 1/4”
clearance inwards to the width and height of the cooling unit. By not going
through, leave 1/2” lip inside at the wall to place the gaskets (see Fig. 2.1 &
2.2).
•
If top exhaust installation, cut another rectangular opening at the top of the
cabinet to the length and width of the top exhaust (see Fig.2.1 & 2.3).
•
Install 2 pieces of 1/4” ID wood thread inserts at the ceiling (see Fig.2.1 & 2.4).
•
Place the gaskets (1/2” foam tape) on the gasket lips (see Fig 2.5).
•
If top exhaust, place another gaskets along the top exhaust at the top of the
cooling unit (see Fig.2.6).
Содержание WINE-MATE WM-1520CD
Страница 9: ... 8 Fig 2 4 MOUNTING SCREW INSERT Fig 2 5 REAR GASKET Fig 2 6 TOP EXHAUST GASKET ...
Страница 10: ... 9 Fig 2 7 COOLING UNIT MOUNTED ...
Страница 19: ... 18 Wiring Diagram Fig 6 1 WIRING DIAGRAM ...
Страница 20: ... 19 Fig 6 2 WIRING DIAGRAM ALARM CALL ...