Vinotemp VT-DSIDM-R, Руководство пользователя

Страница: 6 / 21

INSTALLATION INSTRUCTIONS
BEFORE USING YOUR
ICE MAKER

Remove the exterior and interior packaging.

Before connecting the Ice Maker to the power source,
let it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling
system from handling during transportation.

Clean the interior surface with lukewarm water using a
soft cloth.

Attach the water inlet and outlet pipe, loosen the
screwnut, choose the function switch. (See Ice Maker
Performance Mode instructions.)

Before first use: Make two full batches of ice and
then discard to insure that future batches are clean
and sanitary.
ATTENTION

Do not open the door unless necessary.

If the Ice Maker will not be used for a long period, it is
suggested, after a careful cleaning, to leave the door
ajar to allow air to circulate inside the cabinet. This will
minimize the formation of condensation, mold and
odors.
INSTALLATION OF YOUR
ICE MAKER

Place your Ice Maker on a floor that is strong enough
to support it when it is fully loaded. To level your Ice
Maker, adjust the front leveling leg at the bottom of the
unit.

Locate the Ice Maker away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct
sunlight and heat sources may increase electrical
consumption. Extremely cold ambient temperatures
may also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the unit into an exclusive, properly installed,
grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or
grounding should be directed toward a certified
electrician or an authorized service center
.
INSTALLATION
SPECIFICATIONS (BUILT-IN)
TOOLS YOU WILL NEED
FOR YOUR SAFETY:
While performing installations described in
this section, gloves, safety glasses or goggles
should be worn.
SrewdriverPhillipsLevelCarpentersSquareFlashlightMeasu

It is recommended that you do not install the unit
directly beside a wall. This is to allow the door to have
a greater than 90° opening swing. A limited door
swing may lead to damaging the door gasket.

The rough cabinet opening must be on a level floor
area at least 25" deep and 17 " wide. The opening
should have a height of at least 35".

The electrical outlet may be positioned from within
either side of the adjacent cabinetry, or the rear of the
shaded area (as shown in Fig A).

If the electrical outlet is located inside the adjacent
cabinetry, cut a 1-1/2” diameter hole to admit the
power cord. If the cabinet wall is metal, the hole edge
must be covered with a bushing or
grommet.
INSTALLATION OF
YOUR ICE MAKER
BEFORE USING YOUR
ICE MAKER INSTALLATION
SPECIFICATIONS (BUILT-IN)
3
17”