Vinotemp VT-46TS-2Z, Руководство пользователя

Страница: 9 / 16

9
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
LIGHT
To control the inner light turn on/off.
UP
Used to raise (warm) the set temperature by 1°C or 1ºF.
DOWN
Used to lower (cool) the set temperature by 1°C or 1ºF.
ºF/ºC
Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature
from Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold
mark for 5 seconds.
KEY LOCK
If in 2 minutes without touching any key, the controls will be locked automatically. To release the lock,
touch the
and marks at the same time for at least 5 seconds.
TEMPERATURE ZONES
The wine cooler has two temperature zones with a temperature range of 40°-72°F. The recommended
temperature setting for each zone is:

Lower Zone between 55°-72°F (Ideal for red and white wines)

Upper Zone between 40°-55°F (Ideal for sparkling and white wines)
NOTE: The temperature set for the Lower Zone must always be the same or higher than the
temperature set for the Upper Zone. For optimal performance, the set temperature of the two zones
should differ by at least 4°F.
SETTING A TEMPERATURE

Touch SET to set the internal temperature for each zone. The degrees indicators will appear in
the display window marked for UPPER ZONE and for LOWER ZONE.

When you touch SET for the first time, the LED readouts will show the original temperature
settings (preset factory setting for UPPER ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC /
60ºF).

Touch SET once. The left LED indicator for UPPER ZONE will flash. Then touch UP or
DOWN to set the desired temperature.

When you touch SET again, the right LED indicator for LOWER ZONE will flash. Then proceed to
touch the UP or DOWN to set the desired temperature for the LOWER ZONE.

The temperature will increase by 1°C or 1ºF if you touch UP once, or the temperature will
decrease by 1°C or 1ºF if you touch DOWN once.

To view the set temperature in either zone at any time, touch UP or DOWN and the set
temperature will temporarily flash in the LED display for 5 seconds. You can touch SET to view
the temperature setting from one zone to the second zone.
NOTE
: When using the unit for the first time or after a long period of inactivity, there may be a
variance of a few degrees between the selected temperature and the temperature indicated on the
LED readout. This is normal due to the length of inactivity, and will correct itself after the unit is run for
a few hours. If the unit is unplugged, has lost power or is turned off, wait 3 to 5 minutes before
restarting the unit. The unit will not restart before this time delay.