INSTALLATION
Remove all packing material before using your wine cooler.
IMPORTANT
: Before connecting the unit to a power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water and a soft cloth.
This unit is designed for freestanding and built in installation and indoor use only. Position the unit in a dry and
well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct sunlight.
Do NOT install the unit in a location with an ambient temperature that will fall below 60°F
.
For built-in installation, leave a
1/4” (6.35mm) space on each side and at the top, and 1-2”
(2 5 . 4 ~5 0 .8 mm) at t h e b a ck of t h e wi n e c o ol e r to ensure proper air circulation to cool the compressor
and condenser. Also, be sure to not obstruct the front exhaust vent with any objects as this may affect the unit
from performing properly.
For freestanding installation, leave
6” of space at the back, 10-12” of space on each side, and unlimited
clearance at the top of the beverage cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this will
not allow for proper air circulation.
Do not slide the unit into place.
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To leve l the wine
cooler, adjust the front leveling legs at the bottom of the wine cooler.
For best performance it is recommended that you install the appliance in a location with an ambient
temperature between 72-78°F
.
If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected.
It is recommended that you do not install the appliance near an oven, radiator or other heating source. Direct
sunlight may affect the acrylic coat
ing and heat sources may increase electrical consumption. Don’t install in a
location where the temperature will fall below 60°F (16°C). For best performance, do not install the appliance
behind a cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the beverage cooler into an exclusive, properly installed-grounded wall outlet.
INSTALLING THE STAINLESS HANDLE
This wine cooler includes a stainless handle that is not required to operate this unit. To install the handle
please follow the below instructions:
1. Pull away the door gasket in the area where the
handle is to be installed. You can see two
designated holes for handle installation. The gasket
is easily displaced by hand, no tools are necessary.
2. Install the handle tightly as shown below with the
two screws, lock washers and flat washers
provided. (DO NOT over tighten as this will cause
damage to the handle assembly and stainless steel
surface of the glass door).
3. Replace the door gasket to its original position.
8
9
