VINCENT STU-2, Инструкция по эксплуатации

Страница: 30 / 60

30
Vincent
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
To make the most of the components’ sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
RCA connections
Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows: red for the right
channel, black or white for the left channel.
Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1 2
O U O U T P U T
- wrong - - correct -
INSTALLATION
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device (18). Connect the other end of the mains cable to a mains socket.