12
1.3.3 Installation precautions
- To prevent overheating the device, arrange it in a position allowing the flow of air through the slots in the casing. Ensure at
least 5 cm of free space when installing inside a rack. For the same reason, do not install sources of heat, such as radiators
or hot air ducts. Keep away from direct sunlight. Do not install in areas subject to excessive dust, mechanical vibrations or
shocks.
- Do not arrange this device on an unstable surface, such as a tottering or slanted table. The device could fall causing injury or
mechanical failures.
- Do not install the device in a place where it could be exposed to humidity or water. Do not direct a jet of water onto the device:
risk of fire, electrocution or mechanical failure.
- Stop using the device if water or other material should penetrate inside: risk of fire and electrocution. Contact the retailer or
authorized installer.
- Slots and openings in the cabinet are provided for ventilation. These openings must not be blocked or covered.
- Do not place heavy or heat generating objects on top of the device: this could damage the casing and/or increase internal
temperature causing faults.
- Do not cover the device with a cloth while it is running to prevent deforming the external casing and overheating the internal
parts: risk of fire, electrocution and mechanical failure.
- Keep magnets and magnetized objects away from the device to prevent faults.
- Do not use the device in presence of smoke, vapor, humidity, dust or intense vibrations.
- Wait for a while before operating a device immediately after transporting it from a cold place to a warm place and vice versa.
Wait on average for three hours: this will allow the device to adapt to the new ambient (temperature, humidity, etc.).
- The monitor is provided with a plastic base and rubber feet. It can be positioned on a horizontal surface, such as a desk or a
table. Make sure that the device is fastened firmly and that it is not resting on unstable supports or surfaces. Dropping could
cause severe injury and damage the device.
- Remember to adjust the brightness and contrast to obtain a perfect image.
- The monitor can also be installed on the wall by means of a bracket (not provided).
1.3.4 Cleaning the device
- Rub delicately with a dry cloth to remove dust and dirt.
- Dip the cloth in neutral detergent if dirt cannot be eliminated with a dry cloth alone.
- Do not use volatile liquids (such a petrol, alcohol, solvents, etc.) or chemically treated clothes to clean the device to prevent
deformation, deterioration or scratches to the paint finish of this product not incompliance with the laws in force.
EN
